There are some things that need to be paid attention to after the flood control emergency pump is operated or shut down. Post-shutdown maintenance can prevent equipment degradation and ensure readiness for the next operation. I hope the following introduction can be used as a reference for users.
Immediately after shutting down the Flood Control Emergency Pump, operators should begin thorough cleaning procedures.
Remove all debris from intake screens and pump housings using low-pressure water streams. Flush the entire system with clean water to eliminate sediment and corrosive elements from internal components. Pay special attention to impeller cavities and seal areas where particulate matter commonly accumulates.
For the power unit of the Flood Control Emergency Pump, conduct a comprehensive inspection after cooling.
Check fuel systems for leaks and inspect air filters for water contamination. Battery terminals should be cleaned and protected with anti-corrosion treatment. Engine oil and coolant levels must be verified, with fluids replaced if contamination is suspected from floodwater exposure.
Electrical components in the Flood Control Emergency Pump require careful drying and inspection.
Use compressed air to remove moisture from control panels and connection points. Verify the integrity of all wiring insulation and terminal connections. For submersible pump models, inspect underwater cables for abrasions or insulation damage.
Proper storage completes the post-operation process for Flood Control Emergency Pump equipment. Store units in dry, ventilated areas with protective covers. Position pumps to prevent residual water accumulation in volutes or piping. Maintain detailed service records documenting operating hours, maintenance actions, and observed irregularities for future reference.
More information about Huaquan Power：http://www.huaquandl.com/
